15
Cleaning your fireplace
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the window frame is
correctly installed;
• Verify that the levers and spring-loaded
bolts are hooked properly to the window
tabs then;
• Pull out the top of the window and
release it to ensure the springs return it;
repeat with the bottom of the window;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly
can:
• Leak carbon monoxide;
• Affect the performance of the fireplace;
• Damage components;
• Cause overheating resulting in
dangerous conditions.
Damages caused by incorrect window
installation is not covered by the Valor
warranty.
Re
fi
t and Check Window
1. Rest the window on the
support at the base of the
fi
rebox and center it on the
width.
2. While pressing the window
against the
fi
rebox, pull
the clamping bars levers
forward and rotate them
inwards to secure the top
of the window.
3. Fit the two spring-loaded
bolts through the bottom
of the window and tighten
to secure the window.
4. Pull the top of the window
forward and release to
check that it opens slightly
and returns con
fi
rming
the good function of the
spring-loaded mechanism.
5. Similarly, check the bottom
of the window by pulling it
forward and releasing it.
6. Apply
fi
rm pressure
around the window frame
to ensure the window is
sealed tight against the
fi
rebox.
7.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and the
frame as indicated.
WARNING
For safety purposes, make sure the
barrier screen is re-installed on the
fi
replace front after maintenance.
8. Re-install the barrier screen on the trim.
