27
27
Installation
x 4
Remove Window
It is easier the remove the window and all the items
packed inside of the
fi
rebox to make the engine lighter
for installation.
1. Release the spring bolts at top and bottom of the
window by pushing and turning 1/4 turn.
2. Lift the window and set it aside in a safe place to
avoid damage.
3. Remove the log pack from inside the
fi
rebox and
set it aside with the window. Please handle the logs
carefully as they are made of fragile material and
can easily be damaged.
Unpack Casing
1. Rough-in the gas line and electrical wiring for a fan
(if any).
2. Decide where the stove should be positioned to
avoid moving it once all the casing is put together.
3. Unpack the casing and follow the instructions
supplied with each model (MFCS01, MFCS02 or
MFCS04).
Reposition Lighting Instructions Plate
The lighting instructions plate is attached to the back of
the engine and may have slid out of its slot. Reposition
the plate if this is the case.
Unclip Remote Control Receiver
Under the engine, the receiver box is clipped
to the burner pipes to facilitate transportation.
Unclip the box and
let it hang while you
fi
t the gas pipe.
3/8” gas line
connection
5/16”
fl
are
Receiver hooked to burner pipes
Fit Gas Pipe & Connector
Fit the pipe and connector supplied with the engine to
the valve. Connect the gas line to the inlet pipe.
Replace Receiver into Position
Once the gas pipe is
fi
tted, clip the receiver on top of
the casting crossbar on the base, to the left hand side
of the valve. Make sure the receiver box is oriented
with its wires towards the back and its Reset button at
the front.
Receiver & clip
Receiver clipped to crossbar in
fi
nal position
QUALIFIED
INSTALLER
Summary of Contents for MADRONA MF28JN
Page 44: ......
