34
behind
support
step edge
in center
Installation
Liners
Ceramic Liners:
The ceramic liner panels consist of
three rear sections in one carton and one end panel in a
separate carton. The three sections are
fi
tted into each
other. Two of the sections are identical. Their step edges
go towards the middle to
fi
t into the middle section.
Glass Liners:
The glass liner panels consist of three
identical rear sections in one carton and one end panel
in a separate carton.
The Glass Liners install in the same manner and order
as the ceramic panels; however they don’t
fi
t into each
other. They sit beside each other
Installation
1. Unpack the liner panels carefully.
2. Remove the rear media tray (3 screws).
Ceramic liner panel sections—top view
3. Inside the
fi
rebox, at the rear of the top panel, and
on the closed side of the
fi
rebox, release the screw
of the 4 panel supports and slide the supports to-
wards the middle of the
fi
rebox.
4. Place the end panel, notch at the top, against the
side wall of the
fi
rebox and rest it on the ledge. Slide
the panel towards the front of the
fi
rebox.
5. Place one rear end panel, top
fi
rst, against the back
wall of the
fi
rebox, square edge outward and step
edge in the center. Slide the panel outward so it is
held behind the mounting support.
Liners