Valor LEGEND G3 738JN, Installation & Owner'S Manual

Page: 10 / 38

Remote Control Operation
Setting the fl ame
Use this setting when you want a particular fl ame level. For instance, you want
to watch fl ames burn at their highest level and you don’t mind if the room is too
hot.
1. To raise the
fl ame, press and hold the ▲ button until the flame gets to the
desired level. Let go.
2. To lower the fl ame, press and hold the ▼ button until the fl ame gets to
the desired level. Let go.
The fl ame level will remain just as you set it.
Automatic ON/OFF
You can set your fi replace to come on before you wake up and turn off after
you leave and then, turn on again just before you come home and turn off
after going to bed.
You can leave it like this for the heating season.
1. Decide what temperature you want your
fi replace to be at. Also, decide
what time you want your fi replace to turn on and off. Finally, decide what
time you want it to come back on and off in the afternoon or evening. For
the
fi rst few times you set the timer, it’s handy to write these times down.
2. Set the temperature (just as you did in the section
Setting the
temperature.)
3. Press the TIMER button and hold it until P1
☼ appears and flashes. Let
go. While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the
time at which you want your fi replace to turn on in the morning.
4. Press the TIMER button and hold it until P1
☽
appears and fl ashes. Let
go. While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the
time at which you want your fi replace to turn off when you leave.
5. Press the TIMER button and hold it until P2 ☼ appears and fl ashes. Let
go. While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the
time at which you want your fi replace will turn on again in the afternoon.
6. Press the TIMER button and hold it until P2
☽
appears and fl ashes. Let
go. While fl ashing, push the buttons ▲ (hour) and ▼ (minutes) to set the
time at which you want your fi replace to turn off in the evening.
Note: If you want to set your fi replace for only one time on and off, set P2
☼
and P2
☽
for the same times as P1
☽
.
The remote will record the P1
☽
off
time for both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go
back to manual settings. Press TIMER to go back to your settings.
When your remote control displays BATT , you need to replace the battery
with a new 9 volt alkaline battery—6LR61/MN1604.
CAUTION
DO NOT USE a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short-circuit to the receiver.
10
OWNER’S
INFORMATION