safely dispersed into the outside atmosphere. Where the appliance is connected
to an unlined brick chimney it is generally unnecessary for the chimney pot to be
replaced or for a terminal to be fitted unless the flue has a diameter smaller than
170mm.
6. PRE-INSTALLATION PREPARATION
6.1 Unpacking.
The carton contains the following:-
1 off
Fire assembly.
1 off
Ceramic fuel effect (In packaging inside firebox).
1 off
Closure plate.
1 off
Smoke match tube.
1 off
Olive & olive nut for gas line connection.
1 off
Literature pack.
Remove all the items carefully to prevent damage.
Some items may be contained in the packaging
fitments - Examine the packaging carefully before
discarding. Check that all the items are present and
undamaged.
6.2 Appliance preparation.
1.
Stand the fire upright.
2
.
Remove the two transit screws from the
upper back panel extensions (See figure 5).
3.
Detach the window surround
(See figure 6).
a) Remove the two screws immediately below
the outer fascia canopy.
b) Lift the surround clear of the slots in the outer
fascia apron.
4.
Remove the control knob by pulling clear of
the gas tap spindle.
5.
Remove the control bezel by unscrewing two
screws (See figure 7).
6.
Detach the fascia by removing the screws at
the fascia sides (See figure 7).
7.
Pull the bottom of the fascia forward while
springing the bottom corners outward to clear
the fixing brackets. Lift the fascia upward and
forward to clear (See figure 7). Place carefully to
one side.
8.
Remove the window unit by removing the screws
each side of the window frame and lifting the unit clear.
Page 17
INSTALLER GUIDE
©
GDC Group Ltd. 2012
Figure 6. Window surround
removal.
Figure 5. Transit screws.
