3
Installation
Installing the V-Module
1. Connect the V-Module’s “Power” terminal to the
power cable, using the included Molex connector.
2. Plug the power cable into an available receptacle,
or hard wire back to available power. Consult local
electrical codes.
3. Connect the V-Module’s “Receiver” terminal to the
“Module” port on the Receiver.
4. Attach Velcro and place the V-Module into the fire-
place as space allows.
5. Connect the light cable connector to the V-Module
(if applicable).
6. Connect the fan cable connector to the V-Module (if
applicable).
Replacing the Receiver
7. Identify and disconnect leads from existing
receiver.
8. Remove and recycle the old receiver.
9. Reconnect the following cables to the receiver (new
cables not required)
•
V-Module cable
•
Ignition cable
•
Interruptor cable (to yellow terminal)
•
Interruptor cable (to red terminal)
•
Wiring harness (receiver to valve)
•
Wall switch cable (if applicable)
•
Battery holder cable (if applicable)
10. Attach Velcro and place the new receiver in place of
the old one.
Note:
If you are only installing the
GV60WIFI
kit
, proceed directly to Step 12,
"Installing the WiFi
Module".
WARNING
When installing any cables or wires in
the steps following, be sure to gather any
extra wire with cable ties and prevent
them touching the firebox or other hot
metal surfaces in the fireplace!
Installing the Battery Holder
11. Install 4 AA batteries in the battery holder.
12. Connect the battery holder cable to the holder and
to the Receiver.
13. Attach Velcro and place the battery holder into the
fireplace as space allows.
Synching the Remote Handset
14. Insert two 1.5 V AAA
alkaline
batteries in the hand-
set.
15. Locate the RESET button on the front side of the
receiver.
16. With a thin object, press and hold the receiver’s
RESET button until you hear one short and one long
beeps. After the second beep, release the reset but-
ton.
17. Within the subsequent 20 seconds, press and hold
the button on the remote handset.
will be
displayed on the handset during the pairing se-
quence. You will hear two short beeps confirming
the pairing is done.
Installing the WiFi Module
18. Connect the WiFi module’s “Receiver” port to the
“SI” port on the Receiver using the cable.
19. Attach Velcro and place the WiFi module into the
fireplace as space allows.
Your upgrade installation is now complete. Supply
power to the fireplace and proceed to
"Valor 10 WiFi
Control Software Instructions",
document 4007972.
SI port
Note:
Install the WiFi module with the Reset
button facing in the direction of easiest access. If
installing in the LX2/2200 fireplace, be sure to place
the module under the heat shield.
Installation