1
Installation Manual
WiFi Upgrade
For Valor heaters using the GV60 Valve
September 2019
4007703
Introduction
Any Valor fireplace using a GV60 Valve may
be upgraded to allow the installation of the
GV60WIFI module, allowing the homeowner
to put the fireplace onto the home’s WiFi
system.
Depending on the existing installation,
some parts of the fireplace may need to
be added or upgraded. This document
outlines the required components and the
instructions to physically install them.
The WiFi module must be wired into a
compatible receiver, complete with SI port
as shown below.
Electrical Requirements
A grounded, single phase, 115VAC power
supply is required for operation of the WiFi
system.
If the AC main power is lost, WiFi operation
will be lost also. Remote operation of the
fireplace (using the remote handset) can
still be achieved if battery power is properly
supplied and available.
WARNING
All electrical installations must
be performed by a qualified
electrician and must be
electrically wired and grounded
in accordance with local
codes, or, in the absence of
local codes, with the National
Electrical Code, ANSI/NFPA 70
or the Canadian Electrical Code,
CSA C22.1.
Wiring Diagram