Servicing & Maintenance
CAUTION
DO NOT USE
a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit to the
receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the
fi
replace cool
fi
rst before touching it.
!
Replacing Batteries
Low battery signal: see page 9.
BEFORE changing the batteries, disconnect the
battery holder from the receiver
.
The appliance uses four 1.5 V AA
alkaline
batteries
for its battery holder and one 9 V
alkaline
battery for
its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the o
ff
-
season will extend the battery life. Should the batteries
lose power, the control may be operated by manually
turning the control knob at the valve or by turning o
ff
the valve at the switch.
To replace the batteries in the battery holder
:
1. The battery holder is located underneath the
fi
rebox
behind the lower panel. Unhook the panel. Grab the
battery holder and pull it out.
2. Disconnect the battery holder.
3. Replace the batteries with 4 AA
alkaline
batteries.
4. Reconnect the battery holder.
5. Put the battery holder back in its position.
6. Hook the lower panel.
Using Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t
been installed, refer to the instructions
further on in this manual for the
installation.
Battery holder
CAUTION
DO NOT
let the cable touch the burner plate above, it
will melt during operation.
16
OWNER’S
INFORMATION
