INSTALLER’S GUIDE
Page 14
Figure 11. Concealed
connection seal piercing
position
Figure 10. “U” Seals
Figure 7. Outer surround
removal
Figure 9. Burner attachment
points
Figure 8. Control linkage
9 P R E P A R I N G A P P L I A N C E F O R
I N S T A L L A T I O N
1.
Remove the two screws securing the bottom of the front
surround to the sides of the convection box. See figure 7.
2.
Raise the front surround to allow the retaining lugs at the
top to clear the slots in the convection box hood. See figure
7 . Carefully remove the surround. Place carefully aside.
3.
Disconnect the control linkage from the burner unit by
removing the shouldered screw which joins the control
linking bar to the control pivot unit.
See figure 8.
4.
Detach the burner unit from the convection box by
removing two screws - see figure 9. Lift the burner unit
clear.
5.
Fit the two small "U" section seals to the bottom edges
of the convection box side flanges. See figure 10.
6.
For concealed connection only: Pierce a hole in the seal
at the back of the convection box. See figure 11. The seal
must envelop the pipe. If the hole is larger than the pipe,
seal it with tape.
Do not pierce the seal unless the supply pipe is to pass through it.