OWNER’S INFO
Owner’s Information
ON
OFF
Manual On/Off Switch
Lighting, Operation and Rating Information
The Lighting, Operation and Rating information is
located on a plate under the burner. To access the
plate, remove the fret or access panel, grab the plate
and take it out to read it. There is important information
on both sides of the plate.
Servicing
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance’s serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
Fireplace Control Devices
There are three ways to control your
fi
replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the
fi
replace
to function. It can be used to shut off the
fi
replace in
case of emergency—see next sub-section.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 24–27.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the
fl
ame height—see
1265WSK—Wall Switch Kit.
NOTE:
The remote control in the AUTO mode will
override the wall switch.
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi
replace cool
fi
rst before touching it.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your
fi
replace.
Handset and Wall Switch:
Press and hold the OFF
button for a second.
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Manual ON/OFF Switch:
Press the
O
button.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your
fi
replace will not turn on when you
don’t want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
Remove all batteries from the receiver as well as the
battery from the handset.
Alternately, you can prevent your
fi
replace from lighting
by pressing the
O
button on the manual ON/OFF switch
on the gas valve—see image above.
Automatic Shut-Off
(in certain conditions)
Your
fi
replace’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 27 in the
Remote Control
Operation
section for a description of this feature.
ON
OFF
Wall Switch
(optional)
Manual On/Off Switch
Thermostatic Remote
Control
Wall Switch
(optional)
Remote control
handset
23
