Designed and Manufactured by / for
Miles Industries Ltd.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valor
fi
replaces.com
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
Reassemble Fireplace
Reverse all the previous steps taken in the previous
section,
Prepare the Appliance
, on page 2.
Consult the appliance`s
Installation Manual
for full
details of the above steps.
Adjust the air shutter
Once the burner module reinstalled, the air shutter is at
the left of the
fi
rebox.
1. Locate the aeration adjustment lever.
2. Adjust the aeration lever as required. Depending on
fuel bed used, altitude and other considerations, the
fl
ame picture may be improved by adjusting the
aeration. The need for adjustment should be
determined only by operating the appliance with the
fuel bed, liners and window installed and evaluating
the
fl
ame picture after a 15-minute warm-up.
Airshutter open
Airshutter closed
Fit the Speci
fi
cations Label
1. Complete the required details of the new label:
“This appliance was converted on... by...”
etc.
2. Fit the conversion label with new speci
fi
cations over
the corresponding speci
fi
cations on the data plate
attached to the
fi
replace at right hand side between
the
fi
rebox and the outer case of the appliance.
3. Complete the
fi
replace installation.
6
