Fitting the fascia.
1.
Remove the fascia from its packaging.
2.
As supplied the fascia support brackets may
be flat against the heater body. Using a suitable
tool or gloved hand bend the brackets as in
figure 15.
3.
Hold the fascia firmly and lift into place.
Locate the fascia hanging brackets into those on
top of the heater (See figure 16). Lower the
fascia into place and swing the bottom of the
fascia towards the heater.
4.
Secure the fascia through the holes in the
lower side legs of the fascia using two washers
and two M4 x 25mm screws supplied.
Fitting the firefront.
1.
Remove the firefront from its packaging.
2.
The rear of the firefront may be fitted with
hanging screws or they may be supplied in the
firefront packaging. Where they are not already
fitted insert them into the lower holes on both
sides of the firefront. The distance between the
firefront and the underside of the screw heads
should be approximately 12mm. The screws
can be adjusted to obtain the required fit
(See figure 17).
3.
Hang the firefront on the keyhole slots on
the heater.
4.
Position the ash pan cover beneath the
firefront.
INSTALLER AND OWNER GUIDE
Page 16
©
Baxi Heating U.K. Limited 2010.
Figure 17.
Figure 16.
Figure 15. Fascia support brackets