Fitting the Innova fascia.
If fitting the Innova into an elevated position please see the next section on page 17.
1.
Remove the fascia from its
packaging.
2.
There are two magnets on the
lower rear of the fascia. They should
rest against the outer edge of the two
raised sections (See figure 15).
Ensure that they are located correctly
before fitting the fascia.
3.
Hold the fascia firmly and lift into
place
.
Keeping the magnets away
from the body of the heater, locate
the fascia hanging brackets into
those on top of the heater (See
figure 15). Lower the fascia into
place and swing the bottom of the
fascia towards the heater to engage
the magnets.
Fitting the Innova baffle.
When fitting the Innova into an
elevated position
there is baffle
supplied with the Elevated
Installation kit. This baffle will
improve the flame effect in elevated
positions. Although supplied in the
kit, a baffle may have already been
fitted to the rear of the Innova
fascia; if so, ignore this section.
1.
Lay the fascia face down on a
flat surface.
2.
Secure the baffle to the rear of
the fascia as in figure 16 using the
two No.8 x 5/16 screws supplied.
Page 17
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2009.
Figure 16. Fitting the Innova baffle
Figure 15. Fitting the Innova fascia.
