LOCKING WINGS
4 x ø 160 female
UNIT WEIGHT CA. 71 KG
19
VALLOX DIGIT2 SE/VKL/MLV
© VALLOX • We reserve the right to make changes without prior notification.
INSTALLATION/Ceiling and wall mounting
15
25
DET1
1:2
596
548
45
8
569
15
25
DET1
Wall mounting
DIGIT2 SE is mounted on the wall with a fixing plate as shown in the adjacent figure.
Wall construction
Pay attention to the wall construction when mounting the unit. Avoid mounting the unit on
a hollow, echoing dividing wall and on a bedroom wall because of sound conduction,
or prevent sound conduction.
Wall mounting of
VALLOX DIGIT2 SE
Top part of wall bracket
Bottom part of wall bracket
Wall bracket mounted
Location of DIGIT2 SE
DIGIT2 SE is mounted in a place where temperature does not fall below +10 ºC. Without
protective casing, the unit has to be located in a place with no acoustic disturbance:
storerooms, utility rooms etc. DIGIT2 SE can also be located in a damp room, but not
in a bathroom next to a sauna bath.
CEILING MOUNTING
VALLOX DIGIT2 SE can be equipped with an optional easy-to-use ceiling mounting plate
(patent pending). The ceiling mounting plate is fixed to the ceiling with M8 thread bars.
Fix the bars so that they stand the weight of the unit, i.e. approximately 71 kg.
The ceiling mounting plate has to be fixed horizontally in order to ensure that the unit will be
straight. The outdoor air duct must be insulated against condensation, also between the unit
and the ceiling mounting plate.
Installation
Lift the unit straight upwards, till the locking wings on the sides of the mounting plate lock
into the side plates of the unit. You can detach the unit from the mounting plate by
releasing the locking wings from the side plates.
To facilitate mounting, you may use a lubricant, such as O-ring grease, in the collar seals.
Mounting accessories include rubber silencers, base plates and nuts. Thread bars are
not included in the delivery.
Ceiling mounting plate before
fastening
back edge
of the side
plate
back edge of the
ceiling mounting
plate
DET 2
3
1
2
1
45
-0.0
+3.0
DIGIT2
23
4
Wing
Wall mounting
bottom bracket
Wall mounting
top bracket
Condensing water
The delivery includes a water seal. By connecting a pipe to the water seal the water
condensing from extract air can be led to a floor drain. The pipe must never be connected
directly to the drain. The condensing water pipe must have a downward slope.
The unit comes with separate instructions for mounting and using the water seal.
17.5
42
30
17.5
32
48
7.
5
45
0
16
16
DIST
ANCE BETWEEN
TOP AND LOWER BRACKET
Space between wall
and unit = 4
After the unit has been
mounted, the space
between the wall and
unit can be shortened by
tightening the top
bracket.
2
Note!
Distance between
straight-line wing
and wall is 2 mm.
1. M8 nut
2. Washer
3. Rubber vibration damper
4. M8 threaded bar
Top edge
of side plate
of unit
lower edge
of ceiling
mounting plate
