Wall mounting
VALLOX 70 C0MPACT is mounted in a place
where temperature does not fall below
+10 ºC. Without protective casing, the unit
has to be located in a place with no acoustic
disturbance: storerooms, technical rooms etc.
VALLOX 70K COMPACT is mounted in the
kitchen above the cooker. NOTE! Minimum
distance of grease filter from cooker 480 mm.
Wall construction
Pay attention to the wall construction when
mounting the unit. Because of sound conduction,
avoid mounting the unit on a hollow, echoing
dividing wall or on a bedroom wall, or prevent
sound conduction.
Fixing
VALLOX 70 COMPACT / VALLOX 70K
COMPACT is mounted on the wall with a fixing
plate as shown in the adjacent figure. The
units allow depth adjustment of circa 25 mm.
Remove door A and upper moulding B; then
open screws C, adjust depth as desired by
sliding rail D, and tighten screws C. Adjust
unit straightness with screws E.
Hood mounting
In VALLOX 70K COMPACT, the hood is
mounted directly below the unit. Open the
knurled-head nuts F at the bottom of the unit
and remove the transport support. Open the
bottom plate of the hood with grease filter
attached, lift the hood against the bottom of
the ventilation unit, and fix the hood with the
knurled-head nut F. It is possible to adjust the
hood by
±
10 mm in depth as compared to
the ventilation unit.
Lower edge
of bracket
10
During mounting the unit rises
10 mm higher than
the final height.
163
B
A
C
C
D
D
Wall mounting plate
E
F
F
F
A
A
B
B
A - A
B - B
0...25
depth adjustment
162
12
21
20
60
20 30 30
20
60
11
20
30
30
11
84
84
35 30
35
ø7 14 pcs
550
30
25
25
Wall mounting plate
30
°
Insert the groove of
the fixing moulding (A)
at the upper of the
covering door to the
projections (B) at the
upper edge of the
ventilation unit’s door.
Press the magnets (C)
at the lower edge of
the covering door on
the door of the
ventilation unit.
VALLOX 70K COMPACT
Mounting of covering door brackets
Lower edge
of covering door
592
Fixing
moulding (A)
Glue the magnet tape (C)
Screws
3.5*15
582
40
40
40
40
=
=
Cover the screw-heads with felt tape
Covering
door
598
B
A
B
A
C
Mounting
of covering door
Fasten the fixing
moulding (A) to the
covering door at the
point shown in the
figure, using screws
3.5*15 supplied with
the unit.
Cover the screw-heads
with felt tape.
Glue the magnet (C)
to the covering door
at the point shown in
the figure.
© VALLOX • We reserve the right to make changes without prior notification.
What the units include can vary depending on the sales area.
INSTALLATION
11
VALLOX 70 COMPACT
