© VALLOX • We reserve the right to make changes without prior notification.
VALLOX 280
INSTALLATION
15
Silencer
General
• The silencing unit is meant as a duct silencer mounted
upon the VALLOX 280 unit. The unit has an opening
cover, thanks to which the unit can be cleaned wit-
hout detaching the ducts.
• The unit also incorporates detachable lamellar silen-
cer plates in supply and extract air ducts.
• 4 external joints with a diameter of ø 250 mm are
used as duct joints, allowing the leading of ductwork
directly from the unit with curved sections, for instan-
ce.
• The top of the unit has lead-in seals for the lead-in
pipes of cables and also for the supply and return
water pipes of a water-circulating heater if such a
heater is used.
• The weight of the silencer unit is 105 kg with door,
and 82 kg without door.
Installation
NOTE! BEFORE INSTALLATION CHECK THE MODEL OF
VALLOX 280 (L or R).
• Detach the door of the silencer unit. (See the adjoi-
ning figure.)
• Pierce the lead-in seals on VALLOX 280. (See figure
item D.)
• Pierce the lead-in seals at the bottom of the exhaust
air duct of the silencer unit (no insulation inside).
NOTE! VALLOX 280 model L or R. (See the figure.)
• If VALLOX 280 is equipped with a water-circulating
heater, also detach the lamellar silencer plate in the
supply air duct of the heater.
NOTE! VALLOX 280 model L or R. (See the figure.)
• Lift the unit on top of VALLOX 280.
• Mount the lead-in pipes (included in the delivery) for
cables in place by pushing them first through the
lead-in seals located at the top of the silencer unit
and then through the lead-in seals in the VALLOX 280
unit.
• Thread necessary cables through lead-in pipes to the
connection box located within VALLOX 280.
• If you use a water-circulating heater, mount the supp-
ly and return water pipes for it (not included in the
delivery) through the lead-in seals located at the top
of the silencer unit and VALLOX 280, and connect
them to the supply and return water outlets, using
e.g. a straight connector. (See items A and B in the
figure.)
• Mount the lamellar silencer section in place.
• Carefully fix the door of the silencer unit in place.
• Fix the ducts steadily and tightly to the relevant out-
lets. Implement duct insulation if needed as defined
in the ventilation plan.
VALLOX 280 L
(Note model)
Supply and return water pipe
ø
15/13 2 pcs
Silencer unit
(Note! VALLOX model)
Lead-in seal for supply
and return water pipe 2 pcs
Supply and return water pipe
ø
15/13 2 pcs
Duct connection
ø
250 4 pcs
Straight connector
MS 15 2 pcs
Cable lead-in pipe 3 pcs
Supply and return
water outlet 2 pcs
Lead-in seal for cable
lead-in pipe 3 pcs
Lamellar silencer section
Cable lead-in pipe 3 pcs