10
Step 18:
View from beneath the overhead
bracket. These bolts are the primary
attachment for the overhead, so make
absolutely sure they are solidly
threaded, and fully tightened.
Step 21:
Secure the diffuser brackets once the
lights are functional and the diffuser
grid has been installed.
15.
On the Rear Side of the table, have one person hold and stabilize the overhead,
and another person connect the wire harness from the table to the overhead and
install the Mounting Bracket Cover. Thread all six ¼” Black Bolts usin
g the included
washers and then tighten fully.
16.
Install the two hex head bolts through the BOTTOM of the Rear side Wall Side
Mounting bracket. Make sure they thread into the bottom of each tube as these are
the primary attachment for the overhead. If these cross-thread, come loose or are
otherwise not secure, your overhead will not be secure. Fully tighten these bolts.
17.
Install the remaining two black bolts into
the Front Side Wall Mounting bracket and you
may now fully tighten all six bolts.
18.
Now install the two hex head bolts through
the BOTTOM of the Front side Wall Side
Mounting bracket. Make sure they thread into the
bottom of each tube as these are the primary
attachment for the overhead. Fully tighten these
bolts.
19.
You may now reinstall the fluorescent overhead
light bulbs, make sure they are properly seated and lock into place.
20.
Apply power to the table. Both bulbs should illuminate immediately. If either or
both bulbs do not illuminate, check to make sure
they are seated to the sockets as described in step
18. If the bulbs still do not illuminate, contact
Valley-Dynamo Tech Support.
21.
Reinstall the safety diffuser, secure the diffuser
brackets using the
⅝
” Phillips
screws and #10 black
washers.
