Valiani OMNIA, Instruction And Maintenance Manual

Page: 7 / 66

OMNIA
3
1.5 SAFETY PRECAUTIONS (CAUTION)
Caution
Do not use or store the machine in a location exposed to direct sunlight or the direct draft of an
air conditioner or heater. Such locations may impair the performance of the cutting plotter.
Do not use the machine in an excessively dusty or humid location. Such locations may impair the
performance of the cutting plotter.
Do not place any receptacle containing water or other fluid on top of the cutting plotter. Fluid
falling inside the cutting plotter could cause electric shock or create a fire hazard due to current
leakage.
Do not use the cutting plotter in a location subject to excessive mechanical vibration or electrical
noise. Use in such locations may impair the performance of the cutting plotter.
When disconnecting the power cord or interface cable, do not pull on the cord/cable. Such action
will damage the cord/cable, resulting in a fire hazard or, possibly, an electric shock.
Do not clean the cutting plotter using volatile solvents such as thinners or benzene. Such actions
may impair its performance.
Provide sufficient space around the cutting plotter so that it does not strike any objects in its
vicinity during cutting or plotting. Such contact may cause cutting or plotting to go out of
alignment.
1.6 CEE REGULATION
This manual has been written in accordance with the directions of CEE DIRECTIVE 2006/42/CE as detailed in the machine
design definition. User instructions are an integral part of the machine. The criteria used for writing comply with the
indications of the EUROPEAN STANDARD EN - 292 and, in particular, the point related to USER INSTRUCTIONS
(instructions, general requirements and nature of the instructions).