VALIANI
Astra
Use and Maintenance
15
2)
The blade overcuts the starting point
IMPORTANT: Do not unscrew the nut K.
In this case you must move the stop 3 towards the top (eg, if the stop 3 was at 5cm and the
overcut was of 2 mm, you will move the stop to 5.2 cm).
You make another cut placing the stop 2 at 5cm and the stop 3 at 5.2.
If you obtain perfect results, you will move the measuring arm As2 until the indicator on the
stop 3 reads 5cm.
If this does not occur, repeat this procedure moving slightly the stop 3 until you obtain perfect
angles.
As2
K
2
3
1
