- 15 -
REPLACING THE BLADE
!
!
IMPORTANT! Before any replacements,
switch the tool off, wait for it to come to a
standstill, and unplug from the power supply.
!
!
IMPORTANT! After use the blade reaches
high temperatures: wait for it to cool down
before replacing it.
!
!
IMPORTANT! The cutting parts can cause
serious injuries – use protective gloves!
!
!
IMPORTANT! The assembly of the blade
must be carried out with absolute precision.
Incorrect assembly causes very serious
danger.
Before proceeding, closely observe the compo-
nents of the tool and fig. C. If you are not familiar
with handling and assembling mechanical
components, we recommend that you consult
an authorised service centre.
1. Wear protective gloves.
2. Unplug the tool from the electric power
supply.
3. Clean the blade holder area carefully using a
non-metallic brush.
4. Activate the blade coupling device (7) by
rotating the ring (see fig.C)
5. Pull the blade (5) outwards.
6. If necessary clean the blade holder housing.
7. Grip the new blade (5) on the toothed part
and lubricate the shaped end with a thin layer
of grease.
8. Keeping the coupling device activated, slide
the shaped end into the blade holder slot. The
toothed edge of the blade should face toward
the bottom of the tool (fig. A).
9. Release the blade coupling device. Pull the
blade outwards to check it is fastened well.
10. Ensure the correct assembly of the
components, that the screws are tightened
and the blade is secure.
11. Do a dry run for 1 minute, keeping the tool
away from you.
PROBLEMS, CAUSES AND SOLUTIONS
PROBLEM
CAUSES
SOLUTIONS
The electrical
tool fails to
start
Power supply line
disconnected
Check the electric
power supply line
Plug not inserted Insert the plug in
the electric power
supply socket and
press the star t
button
Switch in off
position
Press the switch
in the ON position
Motor brushes
worn (not visible
from the outside)
C o n t a c t a n
authorised
service centre.
Electrical fault
C o n t a c t a n
authorised
service centre.
T h e t o o l
d o e s n ’ t c u t
very much or
very well
Damaged or dull
blade
Replace the blade
Blade not suitable
for the workpiece
material
Replace the blade
with a suitable
one
Blade speed not
suitable
Acting on the
switch to adjust
the speed
The power tool
vibrates a lot
Damaged or dull
blade
Replace the blade
Incorrectly
assembled blade
Disassemble
the blade, clean
the components
and reassemble
according to the
instructions
The workpiece
is not fastened
sufficiently
I m p r o v e t h e
fastening of the
workpiece
!
!
IMPORTANT! If the power tool still fails
to operate correctly after you have carried
out the above operations, or in the event of
anomalies other than those described above,
take it to an authorised service centre with
proof of purchase and ask for original spare
parts. Always provide the information shown
on the technical data label.
