- 9 -
BEFORE STARTING
The machine is supplied with some parts that
have not been assembled. Unpack the machine
and its parts, which can be easily assembled by
following the instructions given.
While assembling the parts, the power cable
must be disconnected from the power supply.
Before starting the machine make sure that all
parts are securely assembled.
WHEELS (FIG. M)
If not already installed you must install the
wheels (11) in the body of the machine (Fig.M).
Slide the wheels on their pins, insert the washers
and lock with the split pin. Make sure that they
can freely rotate and put the cap on each wheel.
THE HANDGRIP (FIG. C)
The instructions below explain how to mount the
handgrip, refer to figure C.
Detached handgrip.
- Fit the bottom section of the handgrip in place
on the body using the fastener provided in
the kit bag.
- Take the top handgrip and position it on the
bottom section of the handgrip so that the
fastening holes are aligned and then tighten
the fastening system on the top handgrip.
PLASTIC GRASS COLLECTION BOX (FIG. D)
Fit the shells of the grassbox together as shown
in figure D.
Place the handle on the top of the grassbox.
!
!
WARNING! Before mounting the grassbox
on the machine make sure that the motor is
switched off and the blade is stationary. Lift
the stone guard and fasten the grassbox onto
the hooks on the body.
ADJUSTING THE CUTTING HEIGHT (FIG. E)
!
!
WARNING! Before adjusting the the cutting
height, disconnect the power supply and make
sure that the blade is stationary.
To set the desired cutting height, pull out the
adjusting lever and place it on the selected
reference mark.
g
!
!
WARNING! Before using this electrical
appliance always wear personal protective
equipment reported.
!
!
WARNING! Before using this electrical
appliance, carefully read and applied the fol-
lowing instructions, that refer to the drawings
and technical data. Familiarise yourself with
all the controls and how to use the machine
correctly, making sure you know how to stop
it in case of emergency. Improper use of the
machine can cause serious injury.
Keep these instructions and the safety instruc-
tions in a safe place and ready at hand so that
they can be consulted when required.
!
!
WARNING! The lawnmower should only
be used for cutting grass in the garden. Other
uses, not indicated in this manual, may dama-
ge the machine or seriously injure the user.
MACHINE DESCRIPTION (FIG. A)
1
Top handgrip
2
Switch block with power plug and start lever
3
Cable holder
4
Cable clips
5
Top handgrip fastening system
6
Bottom handgrip
7
Body
8
Hood
9
Stone guard
10
Grassbox assembly
11
Wheel
12
Cutting height adjustment system
13
Cutting blade
14
Cutting blade fastening screw
DESCRIPTION OF DECALS AND SYMBOLS
(FIG. B)
1 Machine model
2 Technical specifications
3 Serial number and year of manufacture
4 Certification marks
5 Safety symbols
