- 11 -
Regularly clean and take care of your power
tool, you will guarantee a perfect efficiency and
a long duration.
- Remove dust and machining residues with a
soft bristle brush and a rag.
- Do not spray water or wet electric tools, danger
of infiltration inside .
- Do not use flammable cleaning agents or
solvents.
- The plastic parts are actions brought by
chemicals.
- Pay particular attention to cleaning the switch,
louvers allow the motor to the spindle.
The tool does not require any particular mainte-
nance, internal as it is lubricated with permanent
grease inside the same . A possible internal
audit or the replacement of graphite brushes
should only be performed by an authorized
service center.
PROBLEMS, CAUSES AND REMEDIES
PRO-
BLEM
CAUSE
REMEDIES
The po-
wer tool
does not
start
Power Line
disconnected
Check the elec-
trical supply line
Plug not in-
serted
Insert the plug
into the power
outlet and press
the start button
W o r n e d
g r a p h i t e
brushes
Visit an autho-
rized ser vice
center
Electric fault
Visit an autho-
rized ser vice
center
The po-
wer tool
v i b r a t e s
too much
tightening of
the whip in the
spindle insuf-
ficient
clean the spindle
and repeat the
tightening whip
!
!
WARNING! If after performing the actions
described above, the power tool is not working
properly or in case of anomalies other than
those mentioned , take it to a service center
authorized by showing proof of purchase and
requesting spare parts. Always refer to the
information on the label technical data.
STORAGE
Do a deep cleaning of all the tool and accesso-
ries (see Maintenance). Protect the unpainted
parts with a protective oil and use the original
packaging or in the case (if any) to protect it.
Store the machine out of the reach of children in
a stable position and secure. The place should be
dry and free from dust, tempered and protected
from direct sunlight .
At the local storage should not have access
children and strangers.
DISPOSAL
To safeguard the environment, proceed accor-
ding to the laws of the country where you are.
Consult the competent authorities for more
news on this.
When the machine is no longer usable or repai-
rable, hand it in with the packaging to an official
collection point for recycling. Remove the batte-
ries (if present) and dispose of them separately.
Electric and electronic waste may contain
substances that are dangerous for the envi-
ronment and for human health. For this reason
they must never be disposed of together with do-
mestic waste, but collected separately in specific
collection centres or returned to the retailer when
similar new equipment has been purchased. The
illegal disposal of such equipment may result in
prosecution to the full extent of the law.
WARRANTY
The product is protected by law against non-
compliance with the declared characteristics
provided it is used only in the manner described
in the instructions, it has not been tampered with
in any way, it has been stored properly, has been
repaired by authorized and, where applicable,
have been used only original spare parts.
In the case of industrial or professional use or
when using such a guarantee is valid for 12
months.
To issue a claim under warranty you must
present proof of purchase to your dealer or
authorized service center.
