- 10 -
Remove the machine and check the components
and their visually perfect integrity at this point
proceed to a thorough cleaning to remove any
protective oils used for transportation.
MOUNT WHIP MIX (Fig.C)
!
!
WARNING! During the assembly and
dismantling of the whip unplug it from the
power outlet.
Install the whip mixing and at the end remove
all the keys and check that the hose is centered
and tight.
STARTING AND STOPPING
!
!
WARNING! Before starting the power tool
is required to wear safety glasses, gloves,
hearing protection (not included).
!
!
WARNING! When using make sure that no
one comes to your area of work.
Starting
1) Insert the plug into the power outlet
2) Firmly grasp the handles (pos.2) with both
hands
3) Start press in sequence the security (pos.4)
and the switch (pos.1).
The switch is of the type “Maintained action “
and therefore the power tool will remain lit for
as long as you hold the switch.
Stopping
To stop the device, release the switch.
Wait until the whip stops before removing your
hands from the handle.
We recommend that you repeat these steps a
few times before starting the work in order to
familiarize yourself with the controls as much
as possible.
If you look malfunctions turn off the power tool
and refer to the chapter “Problems, Causes and
Remedies”
When you do not work turn off and unplug it
from the outlet.
INSTRUCTIONS FOR USE
After having read the previous chapters, read
carefully these tips that will allow you to get the
maximum performance.
Take your time to get familiar with all the controls
and only after you have gained a good experien-
ce to be able to exploit fully its potential.
ELECTRONIC SPEED SPINDLE
Turn the wheel (pos.3) till it reaches the desired
speed.
WHIPS MIXING
!
!
WARNING! Observe the max. diameter
specified in the technical data.
Buy quality whips, with an attachment suitable
to the characteristics of the threaded attachment
(M14), the direction of rotation and adapted to
the material to be mixed. Please contact your
dealer who will advise you.
Our company offers a wide range of hoses sui-
table for the most diverse applications.
OPERATION OF MIXING
Prepared separately mix the materials, which
must be contained in a large container and
sufficiently stable, so as to avoid
splashes or rotates under the effect of rotation
of mixing; in addition, check that there are no
impurities such as stones, wires, bollards etc. .
For no reason the material such as water or
other liquids must not come into contact with the
power tool, the only part of the whip is permitted.
Assume a stable position with legs slightly apart,
with mixer disposed vertically above the contai-
ner, the hands must firmly grasp both handles.
For mixer equipped with adjusting the speed of
rotation: started working with a low speed and
then increasing it as necessary.
When mixing, do not hit with a whip container
of the material. At the end turn off the mixer and
remove it from the material.
MAINTENANCE
!
!
WARNING! Before any control or regulation
unplug it from the power outlet.
!
!
WARNING! Do not tamper with or attempt
to repair the power tool.
The duration and the operating cost are also de-
pendent on a constant and careful maintenance.
