- 13 -
ADDITIONAL HANDLE ASSEMBLY (fig.E pos.4)
Put the ring on the front of the auxiliary tool,
paying attention to any shaped seats that need
to engage in a proper fit. Before you fix it, rotate
it in order to find the right position for use. Un-
screw the handle counterclockwise to loosen,
clockwise to secure.
ASTA SWITCH ASSEMBLY (fig.E pos.8)
Insert the rod into the hole and secure it by
screwing into the auxiliary handle itself.
ASSEMBLY TIP / CHISEL (fig.C)
1) Disconnect the power supply by disconnec-
ting the plug from the electrical outlet.
2) Verify that the attack of the tip is compatible
with the spindle of the tool by looking at the
technical specifications of both , you can not
install a bit with different attack or with cylin-
drical shank.
3) Clean out the attack of the tip and the sur-
face lightly greased with grease (see chapter
LUBRICATION).
4) Pull toward you chuck (item 2), this will open
the jaws inside the chuck.
5) Insert the tip, turning it slightly and push it
until it stops background .
6) Release the spindle , the tip will be locked
automatically.
7) Check the locking of the tip by pulling it
outwards .
EXTRACTION TIP / CHISEL ( Fig. D )
1 ) Disconnect the power supply by disconnec-
ting the plug from the electrical outlet.
2 ) Pull toward you chuck (item 2), this will open
the jaws inside the chuck.
3 ) Remove the tip .
4) Release the spindle.
SELECTION OF FUNCTIONS - ROTATION HAM-
MER
Look carefully at the fig.H and operate accor-
dingly.
STARTING, STOPPING AND SPEED ADJUSTMENT
!
!
WARNING! Before starting the power tool
is required to wear safety glasses, gloves ,
mask and ear protection (not included).
!
!
WARNING! When using make sure that no
one comes to your area of work.
Starting
1 ) Grasp both handles firmly with your hands
2 ) To start press the switch (pos.3)
The switch is of the type “Maintained action“ and
therefore the power tool will remain lit for as long
as you hold the switch.
Stopping
To stop, release the switch keeping the unit
securely .
We recommend that you repeat these steps a
few times before starting the work in order to
familiarize yourself with the controls as much
as possible.
If you look malfunctions turn off the power tool
and refer to the chapter “Problems, Causes and
Remedies”.
When you do not work turn off and unplug it
from the outlet.
INSTRUCTIONS FOR USE
After having read the previous chapters , read
carefully the instructions that will enable you to
get the maximum performance.
Take your time to get familiar with all the con-
trols, and only after you have gained a good
experience to be able to exploit fully its potential.
DUST CAP ASSEMBLY (fig.F)
This accessory rubber (pos.14) is useful to
collect dust produced by a vertical drilling. Put
the headset in the tip during use and does not
hold it with your hand.
SNAP OFF AND PERCUSSION
WARNING! The insertion operation percussion
and vice versa , must be performed with the
tool off and the stationary spindle.
Look carefully at the fig.H and operate accordingly.
Do not insert the percussion drilling of metal
or wood.
SNAP OFF AND ROTATION
WARNING! The insertion operation rotation
and vice versa, must be performed with the
tool off and the stationary spindle.
Look carefully at the fig.H and operate accor-
dingly.
