24
© 1999 Directed Electronics, Inc. Vista, CA
troubleshooting
The Valet
®
switch does not work.
■
Is it plugged into the correct socket? See
Plug-In LED and Valet
®
/Program Switch
section. Is the H1/9 YELLOW
wire properly connected? See
Primary Harness (H1) Wire Connection Guide
section of this guide.
Status LED does not work.
■
Is the LED plugged into the small white port on the side of the control unit? See
Plug-In LED and
Valet
®
/Program Switch
section.
Door locks operate backwards.
■
This unit has easily-reversed lock/unlock outputs. Recheck
Harness 2, (+/-) Door Lock Outputs
section to see
if you have reversed these.
The horn honks when the unit enters panic mode, but the confirmation honks do not work when locking
and unlocking.
■
Are the confirmation honks turned on in programming? See
Operating Settings Learn Routine
and
Feature
Descriptions
sections.
I can get into programming and change the feature settings, but when I use the remote the settings seem
to change.
■
Are you using a binary, master dealer remote? Remember, you can program the settings using a master dealer
remote. However, the unit will follow the dealer default settings when using a binary remote to operate the
system
.
