Проверил: Р.Ч./24.03.2015г
Make sure that, when in use, the guard is pressed down as far as possible.
Never load the machine so much that the motor is coming to a standstill.
Never try to brake the saw blade after the machine has been switched off.
Use original accessories only.
ELECTRICAL SAFETY
Always check that the power supply corresponds to the voltage on the rating plate.
DESCRIPTION (fig. A)
Your pendulum action jigsaw has been designed for sawing wood, metal and plastics.
1 On/off switch
2 Lock button
3 Speed adjusting wheel
4 Safety guard
5 Saw blade holder
6 Shoe
7 Pendulum action switch
8 Allen key holder
9 Dust extraction connection
Mounting saw blades (fig. B)
The opening in the saw blade holder (5) must be clean and free from saw dust.
Loosen the set screws (11).
Slide the saw blade up to the stop in the saw blade holder (5). Make sure that the
back of the saw blade engages in the slot of the guide roller (12).
Tighten the set screws (11) firmly.
The set screws (11) may loosen during use by vibration and damage the saw blade. Regularly
check that the saw blade is fastened firmly and if necessary fasten the set screws. Only carry
out this inspection when the machine has been switched off, the plug has been removed from
the wall socket and the saw blade has come to a stand still!
Sharp saw blades produce the best result. Replace worn saw blades on time by new ones.
Remember that continuous use of worn saw blades reduces the accuracy of the machine and may
lead to overloading the motor!
Cutting of mitre angles (fig. C)
The max. mitre angle to the left/right is 45°.
Loosen the set screws (13).
Tilt the shoe (6) to the required mitre angle.
Tighten the set screws (13) firmly.
Using the pendulum action switch (fig. A)
The pendulum action switch (11) is used to set the correct sawing angle for the material.
Turn the switch (7) to the required pendulum action position. Refer to the
table below for the correct pendulum action position for different materials.
Material
Pendulum action position
Wood
I-II
Plastic
I
Aluminium
0-I
Steel
0
Ceramics
0
Rubber
0
