Valeport miniIPS2, Operating Manual

Page: 21 / 46

Setting Up the mniIPS2
©
2020 – Valeport Ltd Page | 18
5.10 Information #Codes
The following commands will cause the sensor to report back various pieces of information, as described:
# Code Description
#004 Read the sampling rate
#006 Read the address mode status
#008 Read Tare activation status
#010 Read Tare value
#012 Read operating mode
#014 Read data string output format
#015 Read the last measured observation
#019 Read calibrated units
#021 Read unit status
#023 Read user calibration coefficients
#030 Read number of samples for burst averaging
#032 Read firmware version number
#034 Read instrument serial number
#038 Read User calibration activation status
#045 Reads the Pressure Module serial number
#093 Read PCB serial number
#136 Read the set Latitude
#138 Read Pressure module calibration date
#200 Read Pressure sensor serial number
#202 Read maximum transducer pressure range
#210 Read startup message status - on/off
#701 Reads Modbus activation status
#703 Reads Modbus address