2
947815
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
INSTALLATION
Precautionary Designations
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated in
a commercial environment. This equipment
generates, uses and can radiate radio
frequency energy and if not installed and used
in accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment
in a residential area may cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
Mounting
The VE8004A is designed for wall or table
mounting.
The VE8004A
R is designed for 19” rack mounting
(1U).
Table:
Provided with the VE8004A are four rubber
pads. Peel pads off their carrier backing and place
at the four corners of the bottom of the unit.
Wall:
Secure mounting brackets to the VE8004A,
then secure the VE8004A to the wall. See Figure
1.
Rack:
Secure mounting brackets to the
VE8004AR. See Figure 1. Place the VE8004AR
into a
standard 19” rack and secure to rack with
proper hardware (not included).
Figure 1.
Power Connections
The preferred method of powering a
VE8004A/VE8004AR is via a Power over Ethernet
(PoE) switch meeting the 802.3af specification.
If the rear panel barrel connector is used for power,
the preferred power supply is a Valcom VIP-324D.
Make all required signal connections before
applying power to the unit. If powering via 802.3af,
make sure all signal connections via the back
panel are made then connect the
VE8004A/VE8004AR to the Ethernet switch.
If power is supplied via the barrel connector, make
sure all signal connections are secure. Attach the
unit to the network via the front panel RJ-45
Ethernet connector. Apply power by plugging the
power supply into the VE8004A/VE8004AR via the
barrel connector on the rear of the
VE8004A/VE8004AR.
Network Connection
The VE8004A/VE8004AR has one RJ-45 Ethernet
network connector on the front panel.
Use one of the supplied patch cables to connect
the VE8004A/VE8004AR to an Ethernet switch.
