2
Installation Steps
1. Mount the PagePac
®
Plus AmpliCenter to a 19 inch rack (Figure 1 & 2). Set 115/230 V Switch on rear to proper
voltage (D300A Only).
Note: If installed next to other equipment, including the PagePac Plus Controller and Zone Expansion Units, leave at
least four inches space above and below for proper ventilation.
PRIOR TO TURNING ON POWER CHECK SPEAKER WIRING: MAKE SURE WITH AN IMPEDANCE METER THAT FROM
EITHER SPEAKER WIRE TO CONDUIT BUILDING GROUND IS OPEN AND ACROSS SPEAKER TERMINALS IS:
AMPLICENTER D300A
VALCOM
VALCOM
Figure 1. Rack Mounted Hardware (Front View)
Figure 2. Rack Mounted Hardware (Rear View)
•
16 Ohms @ 1kHz for V-5328300A - (D300A)
•
49 Ohms @ 1kHz for V-5328100A - (D100A)
•
122 Ohms @ 1kHz for V-5328040 - (D40)
