assembly
FIGURE A
1. Lift the handle upward toward you. The frame will begin
to open.
2. Continue opening the frame until you hear it “click” into
the fully locked position.
Install the rear axle/brake bar
FIGURE B
3. With the brake levers (3a) facing AWAY from the stroller,
align the plastic brake housings with the rear legs (3b).
Firmly push each housing onto the corresponding leg
until it locks into place. Test by pulling on the rear axle.
Insert rear wheels
FIGURE C
4. Depressing the button in the centre hub of the rear
wheel, insert each wheel axle in turn, into the wheel
hub. Push the wheel as far as it will go before releasing
the button.
IMPORTANT: PULL EACH WHEEL SLIGHTLY
BACK TOWARDS YOU TO ENSURE THAT IT HAS FULLY
ENGAGED IN THE AXLE.
Insert front wheel
5. Insert the front swivel wheel over the housing on the
front legs. IMPORTANT: BE SURE THAT THE SWIVEL
LOCK LEVER IN THE HOUSING IS AT THE TOP.
6. To fix the front wheel in the non swivel position, turn the
wheel so that the two notches on both housings line
up. Press down firmly on the swivel lock until it locks
into place.
Install the bumper bar
FIGURE D
7. Align the ends of the bumper bar with the housing
located on either side of the seat.
8. Insert the ends into the housing. Keep pushing until
they lock into place. IMPORTANT: NEVER LIFT YOUR
STROLLER BY THE BUMPER BAR.
adjustIng the bumper bar
9. To lower/raise the bumper bar, simultaneously press
the release buttons and move to desired position.
adjustIng the footrest
10. To lower/raise the footrest, simultaneously press the
release buttons and move the footrest to the desired
position.
A
C
D
B
1
2
3a
3b
7
10
9
4
5
6
7
