FIGURE E -ATTACH L-BAR CONTINUED
5. The foot board (1) is supposed to sit 16 cm above the ground,
while secured by two M6 nuts (8) and M6 screws (10) to the
base of the L-bar (9)
WARNING: THE EZ RIDER MUST BE ASSEMBLED SO THAT
THE BOARD IS AS PARALLEL TO THE GROUND AS POSSIBLE.
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY
6. Your EZ Rider should now be level, and firmly mounted in the
centre of the pram, without interfering with its use. If this
is not the case, please go over steps 1-6 again and review
instructions.
*NOTE: If the EZ Rider is being used for standing only, please
ensure the seat mounting hole is covered with the plastic lid (12)
supplied for safety.
FIGURE G- COUPLING STRAPS
7.The EZ Rider is provided with an additional pair of straps to
provide an extra secure connection to your pram. Please
connect these to the neck of the coupling arms and fasten
around the connection as shown.
FIGURE H- STORAGE STRAP
8. The EZ Rider is provided with a storage strap which allows the
EZ Rider to be stowed when not in use. To use attach the strap
to the handle bar and hook the EZ Rider firmly to the pram at
the base (12).
*NOTE: The Storage strap may not be suitable for some baby
buggies, please consult with your product vendor for more
information on specific models
FIGURE I - ATTACH SEAT
9. Remove plastic lid (13) from the foot board and mount on the
seat post (14) for storage. Insert the post at the base of the
seat into the connecting post (14), then insert this assembly
into the foot board (15) and secure from underneath with the
seat fastening bolt. (16)
10. Adjust seat to desired height and secure by inserting screws
into the appropriate and corresponding holes.
WARNING: ENSURE SEAT IS SECURELY FASTENED BEFORE USE.
G
I
1
10
15
16
14
8
7
7
8
9
9
10
1
E
H
13
12
