8
EN
Using the appliance
B
Water Inlet Hose Connection
3/4”
10 mm
1
3
2
4
1. Your machine may have either a single water inlet connection (cold) or double water inlet
connection (hot and cold) depending on the machine specifications. The white capped
hose and red capped hose to the hot water inlet (if applicable).
To prevent water leaks at
the joints, either 1 or 2 nuts (depending on your machine’s specifications) are supplied
in the packaging with the hose. Fit these nuts to the end(s) of the water inlet hose that
connect to the water supply.
2. Connect new water inlet hoses to a ¾ ˝, threaded tap. Connect the white capped end of
the water inlet hose to the white water inlet valve on the rear side of the machine and
the red capped end of the hose to the red water inlet valve (if applicable).
Hand tighten
the connections. If in any doubt, consult a qualified plumber. Water flow with pressure of
0. 1-1 Mpa will allow your machine to operate at optimum efficiency (pressure of 0. 1 Mpa
means that more than 8 litres of water per minute will flow through a fully opened tap).
3. Once you have made all of the connections, carefully turn the water supply on and
check for leaks.
4. Ensure that the new water inlet hoses are not trapped, kinked, twisted, folded or crushed.
If your machine has a hot water inlet connection, the temperature of the hot water
supply should not be higher than 70°C.
