33
EN
Useful information
C
Fault
Possible cause
Troubleshooting
Too much foam has formed
in the dispenser drawer.
Too much washing
product has been used.
Press the Start/Pause button.
To stop foam from forming,
dilute a tablespoon of fabric
softener in ½ L of water. Then
pour it into the dispenser
drawer. Wait 5 to 10 minutes.
Then press the Start/Pause
button.
The wrong washing
product was used.
Only use washing products
made for washing machines.
The result of the washing
cycle is not satisfactory.
The laundry is too dirty
for the selected program.
Use the program table to
choose the most suitable
program.
There isn't enough
washing product.
Use the amount of washing
product recommended on the
packaging.
The drum is overloaded.
Check that the maximum
capacity for the selected
program has not been
exceeded.
The result
of the washing cycle is not
satisfactory.
Hard water.
Increase the amount
of washing product by
following the manufacturer's
instructions.
The laundry is too tightly
packed in the drum.
Make sure that the laundry is
evenly distributed.
As soon as the machine is
supplied with water, leaks
can be observed.
The end of the drain hose
is too low in relation to
the machine.
Make sure that the drain hose
is fitted at a suitable height
(**) .
There is no visible water in
the drum during washing.
No fault. The water is
located in a part of the
drum that is not visible.
.....................
There is some washing
product residue on the
laundry.
Some undissolved
particles of washing
product may occur in the
form of white spots on
the laundry.
Perform an additional rinse or
clean the laundry with a brush
after drying.
