17
EN
Using the appliance
B
• The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for
this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
After installing the hob, make sure that
• The power supply cable is not accessible through cupboard doors or drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
Before locating the fixing brackets
• The unit should be placed on a stable, smooth surface (use the packaging).
• Do not apply force onto the controls protruding from the hob.
Adjusting the bracket position
• Fix the hob on the work surface by screw 4 brackets on the bottom of hob(see picture) after
installation.
• Adjust the bracket position to suit for different table top thickness.
Bracket
Hob
Table
Bracket
A
Summary of Contents for IH 4 TB2FZS 007C
