VALBERG 972343, Instructions For Use Manual

Page: 21 / 118

38
C
Useful information
EN
Mesh filter for water connection
Check and clean regularly.
For washing machines with an inlet hose as shown on pictures,
1. Close the tap and loosen the inlet hose on the tap.
2. Clean the internal mesh filter and screw the water inlet hose back onto the tap.
3. Now unscrew the inlet hose on the rear of the washing machine.
4. Pull off the mesh filter from the washing machine connection with universal pliers and ciean it.
5. Refit the mesh filter and screw the inlet hose on again.
6. Turn on the tap and ensure that the connections are completely water-tight.
A
B
C
39
C
Useful information
EN
Troubleshooting guide
Depending on the model, your washing machine is equipped with various automatic safety
functions. This enables faults to be detected in good time and the safety system can then
react appropriately. These faults are frequently so minor that they can be resolved within a
few minutes.
The washing machine will not start, no indicator lamps are on.
Check whether:
• The mains plug is inserted into the socket and the power switched ‘ON’ .
• The wall socket is functioning correctly (use a table lamp or similar appliance to test it).
The washing machine will not start...
Check whether:
• The door is properly closed ;
• The «
Start/Pause » button has been pressed;
• The «Water tap closed» indication lights up. Open the water tap and press the « Start/
Pause » button.
The appliance stops during the programme (varies depending on model)
Check whether:
• Check if there is too much foam inside, machine enters kill-foam routine. The machine will
run again automatically after a period.
• The washing machine’s safety system has been activated (see «Fault description table»).
Residue from detergent and additives left in the detergent drawer at end of wash.
Check whether:
• The cover grid of the softenercompartmentand the cover grid of the detergent compartment
are correctly installed in the detergent dispenser and all parts are clean (see «Care And
Maintenance»);
• Sufficient water is entering. The mesh filters of the water supply could be blocked (see
«Care and Maintenance»);