6
7
FR
FR
Utilisation de l’appareil
Utilisation de l’appareil
B
B
6
7
EN
EN
Using the appliance
Using the appliance
B
B
B
B
Using the appliance
Using the appliance
Reversed door
Tools required:
• Phillips screwdriver,
• flat screwdriver,
• hexagon key
• Make sure that the appliance is unplugged and empty.
• To remove the door, you need to tilt the appliance backwards. You need to position the
appliance on something solid so that it does not slip whilst you are positioning the door the
other way round.
• All the parts that have been removed must be kept in a safe place so that the door can be replaced.
• Do not lie the appliance flat as this could damage the cooling circuit.
Unscrew the hinge cover.
•
It is better for 2 people to handle the appliance during assembly.
Open the door and unscrew the upper hinge. Then remove the door from the unit and place
it on some soft padding to prevent damage.
Remove the cover and the screws on the left-hand side and then attach them on the right.
Carefully position the back of the unit flat on some soft padding. Start by removing the 2
levelling feet. Then unscrew the door hinge and the adjustable foot on the left.
Caution !
If there is a screw in the front left-hand corner, remove it before installing the hinge.
Unscrew and remove the pin from the lower hinge. Turn the support over and reposition.
Install the hinge on the left-hand side and the adjustable foot on the right. Then screw the
2 levelling feet onto their initial parts
Unscrew the pin in the upper hinge and insert it into the hole on the left.
Return the appliance to its vertical position and place the door on the lower hinge. Make sure
that the centre of the lower hinge is inserted in the hole in the door.
Then attach the upper hinge to the door. Before fixing the upper hinge firmly in place, try to open
the door to check that the unit is properly sealed. Then screw the hinge cover onto the hinge.
Installation
Installing the door handle
Rear spacer
Screw the spacers onto the rear of the element.
Space required
Make sure that there is enough space to open the door.
Maintain at least 50 mm on both sides.
Levelling the appliance
To complete this step, adjust both feet on the element.
If the appliance is not level, the door will not be properly aligned and the magnetised seals
will not be properly covered.
Positioning
• Install this appliance in a place where the room temperature corresponds to the climatic
class indicated on the appliance's nameplate.
Location
• The appliance should be installed far from heat sources such as radiators, boilers, direct
sunlight, etc. Make sure that air can circulate freely around the back of the element.
• To guarantee optimum performance, appliances which are positioned below an overhanging
element should be at a minimum distance of at least 100 mm between the top of the appliance
and the wall element. Ideally the appliance should not be positioned underneath wall elements.
• Precise levelling is guaranteed using en or more adjustable feet positioned on the base of
the appliance.
11
12
Summary of Contents for 967523
Page 2: ......
Page 27: ...50 51 Notes Notities Notas Notes Notities Notas ...