VALBERG 1D NF 328 E S180C, Instructions For Use Manual, Page: 6 / 38

8 9 EN EN
Using the appliance Using the appliance
B B
The side, from which the door opens, can be changed to the right (as the appliance is supplied)
or to the left. Caution! When reversing the opening direction of the door, the appliance must
not be connected to the power supply. Make sure that the power has been switched off. Tools
you will need:
1 x 8mm socket spanner
1 Phillips screwdriver
1 flathead screwdriver
1 x 8mm spanner
Description of the appliance
NOTE:
Before laying the appliance down, make sure that the
surface is made of foam or a similar material, so as not
to damage the back of the appliance. To reverse the door,
follow the steps below.
1. Stand the refrigerator upright.
2. Remove element 1 and element 2 from the refrigerator, followed by element 3 located
on the door. Remove the screws 4 and remove element 5 as shown in the illustration
below ( Figure A).
1
Top hinge cover
2
Set of top covers
3
Top cover
4
Special flanged self-tapping screw
5
Top hinge (element)
3. Remove the door 1 and place it vertically on a smooth surface. Unscrew the upper hinge
2 (including the washer) as shown in figures B-II and B-III , then turn it over ( figure B-IV ).
Screw the pin back onto the hinge in the new direction as shown in figures B-V and B-VI .
NOTE:
Hold the door firmly with one hand in step 2 to prevent the
door from falling.
4. Lift the covers of the handles 1 and loosen the screws 2 , in order to remove the handle
3 as shown in figure C-I , then set it aside. Remove the screw covers 4 as shown in figure
C-II . Then fit them on the right side, as shown in figure C-III . Switch the handle to the right
side and install it as shown in figure C-IV . Remove the door stop 5 and the door locking
system 6 . Then fit the stop and the locking system on the left as shown in figure C-V and
C-VI .
1 Handle covers 5 Door stop
2 Screws 6 Door blocking system
3 Handle 7 Self-tapping screws
4 Screw covers
5. Lay the refrigerator down flat, remove element 3 and then loosen the screws 4 . Remove
element 2 followed by element 1 as in diagram (Figure D) .
1 Lower left hinge 5 Adjustable foot
2 Control Panel 6 Special flanged self-tapping screw
6. Unscrew the pin and its washer from the lower hinge, and screw them back onto the thread
on the side as shown in the diagram (Figure E) .
NOTE:
the washer can be attached to the door.
7. Follow step 5 in the same order, placing element
1
on the left and element
2
on the right.
Then fasten them with screws 4 . Finally, fit element 3 (Figure F).
8. Remove element
1
and set it aside, as shown in figure G-I. Move the refrigerator door to
the correct position. Adjust element 2 and the door. Then fasten element 2 using the
screws, as shown in figure G-II (hold the upper door with one hand during installation).
Fasten element 3 as on element 2 (which is in the plastic bag). Fit element 1 at a 180°
angle and fit it on the right side of the door, as shown in figure G-III . Finally, fit element
4 as shown in figure G-IV. (which you removed in step 2).
9. To finish, fit elements
1
and
2
(which you removed in step 2) at the location shown in the
diagram below (Figure H) .