9
20 degrees
Tighten
20 degrees
Loosen
Remove the fuel cap and insert a suction
pump into the fuel tank.
Watch the fuel gauge while refueling. When
the gauge reaches the maximum level, stop
refueling.
Wipe off any fuel that has spilled onto the
fuel tank or elsewhere.
Replace the fuel cap and tighten it securely.
Do not operate the heater with a loose fuel
cap or without a fuel cap.
■
Adjust the angle of the main unit
Prior to operation, loosen the knob bolt to
move and set the main heater unit at the
desired angle, and tighten the knob bolt
firmly.
The vertical angle of the radiation disk is
adjustable up to 20 degrees.
●
KBE5S
●
KBE5L
■
Connecting the Power Supply
Make sure that the operating switch is
“OFF”
, then plug the heater’s power plug
into approved, grounded, three-wire
extension cord.
Plug extension cord into standard 120 volt/
60 Hz, 3-prong grounded outlet.
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 meters) long, use 18
AWG (0.75 mm
2
) rated cord
• 11 to 100 feet (3.3 to 30.5 meters) long,
use 16 AWG (1.0 mm
2
) rated cord
AC Outlet
Extension Cord
Connect
Grounded Power Pin
CAUTION
•
Do not adjust the angle of the main unit while the heater is plugged in, operating, or hot
to avoid severe burns and electric shock.
•
Do not use an adapter to change the power plug or power outlet from grounded (3
prongs or inlets) to ungrounded (2 prongs or inlets) as this improperly overrides the
CAUTION
safety function in grounding the heater by the provided power plug. Also if the power
cord or plug need to be replaced, please be sure to replace it only with genuine or man-
ufacturer-approved replacement parts.
1
3
2
1
2
E
n
g
lis
h