vNet Power over Ethernet Device User Guide
9
18
Insert the Veriteq vNet Device Drivers CD into a PC that
is on the
same
subnet as the device(s) you installed. If
the Software Installation menu does not display
automatically, click
Start
on the Taskbar, then select
Run
. Type
D:\setup.exe
(replace ‘D’ with the drive letter
of your CD-ROM drive), then click
OK
.
19
Click on
Device Discovery Install
on the Software
Installation menu to install the Digi Device Discovery
program onto this PC.
20
Run the Digi Device Discovery program from
Start I
Programs
. The program will display a list of all vNet and
Digi devices found on this subnet.
Note:
If the device you need to configure is not shown,
you may need to change some settings in your
firewall software:
•Allow the dgdiscvr.exe program to receive incoming
network connections. It is typically found in the folder
C:\Program Files\Digi\Digi Device Discovery.
•Unblock UDP port 2362 and multi-cast address
224.0.5.128, as these are used by device discovery.
21
Scroll down the device list until you find the MAC address
of a device that is to have a static IP address assigned.
(The MAC address is on the side of the vNet device
above the serial number, or on the bottom of the Digi
device.) If the device does not appear in the list, wait a
few seconds, then click
Refresh
. Select the device, then
click
Configure network settings
.
22
Select
Manually configure network settings
, then
enter the IP Address, Subnet Mask, and Default
Gateway values for this device. Click
Save
, then click
OK
to allow the device to be restarted.
23
Wait until the device has been restarted and the device
list updated.
24
Repeat steps 21 through 23 for each additional device.
25
When all devices have their desired IP address, refer to
the
Launching the vNet Configuration and
Management Interface
section for further instructions
on opening the web-based interface to change the
password or other settings.
