U
SER
'
S
G
UIDE
_______________________________________________________________________
12 ___________________________________________________________________ M210195
EN
-A
Software settings
SERI Serial bus settings
SERI b p d s x <cr>
where: (* = factory setting)
b
=
baud rate (300...9600*...38400)
p
=
parity (E = even*, O = odd, N =
none)
d
=
data bits (7* or 8)
s
=
stop bits (1* or 2)
x
=
duplex (F = full* or H = half)
<cr> =
carriage return is generated by the
ENTER or RETURN key of the
host computer
The SERI command is used to set or inspect the serial bus settings of
the transmitter.
Examples:
>seri <cr>
9600
E 7 1 F
>seri 1200 N 8 1 H <cr>
1200
N 8 1 H
>reset <cr>
PTU200 / 1.01
>
NOTE
Always give the RESET command after the SERI command to
activate the new serial bus settings.
ECHO Setting the serial bus echo on/off
ECHO x <cr>
where:
x
=
ON or OFF
The ECHO command can be used to set or inspect the echoing
condition of the transmitter. In OFF mode the transmitter does neither
output the '>' prompt character nor echo the given commands.
All manuals and user guides at all-guides.com
all-guides.com
