Vaisala Indigo500 Series, Quick Manual

Page: 28 / 176

6. On your computer, select Start > Settings > Network and Internet > Ethernet >
Unidentified network > IP settings > Edit (this path may vary depending on your
computer and settings).
a. Select Manual .
b. In IPv4 , set the IPv4 connection on.
c. In IP address , enter an address that differs from the transmitter's IP address by its
last digit.
Example:
192.168.5.21
d. Depending on your computer, enter either 255.255.255.0 in Subnet mask or 24 in
Subnet prefix length .
e. If you're using a Windows operating system: in Gateway , enter 192.168.5.1 .
f. Click Save .
7. Open a web browser. In the address field, enter https://192.168.5.20:8443 .
Your web browser may give a certificate error, but you can safely proceed to the
transmitter's IP address. You are next prompted to log in or create users.
Creating web interface users
Allen key (4 mm, provided) for opening the transmitter cover
When you connect to the web interface for the first time, or when you start using the
transmitter after a factory reset, you are prompted to create users for the web interface.
Figure 10 User creation page
The web interface has 2 user levels:
• Administrator : Configuration rights. Can configure outputs and change transmitter
settings.
• Guest : View-only access. Can add and remove measurement parameters in the
Measurements view.
26 M212290EN-D