3.3 Wiring options
1
2
Ø 7 ... 8 mm
Figure 7 Indigo200 wiring options
1
Wiring from the back: cut the seal open and nest the cable in the groove on the back of
the transmitter base
2
Wiring through the rubber lead-through on the bottom of the transmitter
1. To wire the input/output cable through the back of the transmitter:
a. Cut off as much of the seal on the transmitter base as is needed to fit your cable
through the opening.
b. Lead the cable through the cut in the seal.
c. Nest the cable inside the groove on the back of the transmitter as shown in
, and attach strain relief as needed.
To preserve the IP rating of the transmitter, the back of the
transmitter must rest flat on the installation surface. Always nest the
cable inside the groove on the back, so that the cable does not push
the back of the transmitter off the installation surface.
CAUTION!
d. If you wire only through the back, plug or seal the other lead-through on the bottom.
Chapter 3 – Installation
17
