Installation
14
CD-MP3 Emulation Mode Selection (CD-MP3 emulation)
CD-MP3 Emulation Mode programming steps:
Properly install this unit.
Put “Left” programming switch in “DOWN” position.
Put ignition switch into the “ACC” position.
Wait for long beep followed by a few short beeps. This may take up to one minute.
Return programming switches into their default position (both switches “UP”).
Wait up to 30 seconds until confirmation beep.
Put ignition switch into the “OFF” position. Wait at least 10 seconds.
Put ignition switch into “ACC” position.
Check SoundLinQ2 for functionality, especially TEXT capabilities.
!
!
!
!
!
!
!
!
“Hard” Velcro Fastener
Carpet or car chassis
SoundLinQ2
“Soft” Velcro Fastener
Mounting unit using Velcro fasteners
!
!
!
Velcro Fasteners are not included
VAIS Technology strongly recomand to ground unit to the car chassis for best results
Do not more the 5mm size screws. Using screws larger then 5mm may damage the PCB board.
NOTE
M4 x 5mm*
(see note below)
Ignition into
“ACC” or “ON”
position
Both
switches
“UP”
Ignition into
“OFF” position
up to 30 sec
Confirmation beep
Left
switch
“DOWN”
