SIRIUS Radio controls
Presets
NOTE:
Beep indicates successfully accomplished operation. If you do not hear a beep, please repeat the above steps.
@
@
@
Select the desired channel
Press and hold the preset button where you would like to store the current channel.
You will hear a beep when the channel has been stored in the preset location.
Adding a new PRESET
@
Presets can be overwritten at any time using the same procedure as adding a new Preset.
Changing an existing PRESET
@
Presets can not be erased, but they can be overwritten at any time by following the procedure for Adding a new
Preset.
Erasing PRESETS
SIRIUS Radio Input Settings
You can adjust the input sound level of your satellite receiver. The sound level adjustment allows you to balance the
volume control with other sources connected to your head unit (such as CD player, FM radio, etc), and eliminate possible
distortions caused by high input levels.
9
@
@
@
@
@
@
@
@
Activate SETTINGS MODE
To adjust the sound level, first you must select a source that is not connected to the SoundLinQ2 unit, such as CD
player or FM radio. Set the volume to a comfortable level while listening to this source.
Change the source to SAT1 or SAT2 and select a satellite channel to listen to.
Change the source to SAT3.
Press and hold the button labeled SAT Lev Adj or number 5 on the Radio with its own LCD. You will hear a short
beep, and should then hear sound coming from the satellite receiver source.
Now you will adjust the sound level (1..10) to match the volume of the source you selected in step 1. To adjust the
sound level, press either the TYPE < or TYPE > button.
Once the sound level matches the volume of your source from step 1, press the SAT Lev Adj (or number 5 on the
Radio with its own LCD) again to store the desired sound level in memory.
Deactivate SETTINGS MODE
Satellite Sound Level Adjustment
Remember, a high sound level may result in noticeable sound distortion.
NOTE:
SAT Level Adjustment
Activate / Deactivate SETTINGS MODE
@
@
@
@
Go to SAT 3
Tune to channel 255
Press [Type Scan] 8 times to hear long beep.
Using AM or AM/SAT button reselect sources to cycles to SAT 3
SAT3 - “SETTINGS MODE”
