Installation
We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade
the unit or re-program it in case of incorrect programming.
IMPORTANT
i
@
@
@
@
@
@
@
@
@
Gain access to the back of your vehicle’s Head Unit.
Find the same port as our Audio Harness (see
)
Disconnect the existing connector and plug in our Audio connector into this port, then plug female end of Audio
Harness to plug into your factory connector . In some vehicles Audio harness female connector is not used.
Plug the other end of Audio cable into designated port on this unit.
Connect SIRIUS Radio Receiver interface cable as shown in the picture. (see
)
Setup proper Emulation Mode for the unit (see
)
Turn the car on and check SoundLinQ functionality (especially Text capability) before the final assembly.
Please mount this unit in an easily accessible location for upgrading and re-programming purposes.
Secure the Head Unit in its original position.
“Connecting SoundLinQ to head unit”
“Connecting the units”
“Emulation Mode Selection”
Installation
6
Left switch
“DOWN”
Hard RESET (use for RESET purposes ONLY)
@
@
@
@
@
@
@
Properly install this unit.
Put “Left” programming switch in “DOWN” position.
Put ignition switch into the “ACC” position.
Wait for long beep followed by a few short beeps. This may take up to one minute.
Put ignition switch into the “OFF” position.
Return programming switches into their default position (both switches “UP”). Wait at least 10 seconds.
Put ignition switch into “ACC” or “ON” position.
Ignition into
“ACC” or “ON”
position
Ignition into
“OFF” position
Ignition into
“ACC” or “ON”
position
Wait 10 sec
Wait for long beep
“Hard” Velcro Fastener
Carpet or car chassis
SoundLinQ2
“Soft” Velcro Fastener
Mounting unit using Velcro fasteners
!
!
!
Velcro Fasteners are not included
VAIS Technology strongly recomand to ground unit to the car chassis for best results
Do not more the 5mm size screws. Using screws larger then 5mm may damage the PCB board.
NOTE
M4 x 5mm*
(see note below)
Both
switches
“UP”
