Operation 4
0020277263_00 ecoFIT sustain Operating instructions
5
3.4
Information on the identification plate
The identification plate is mounted on the underside of the
product in the factory.
The identification plate keeps record of the country in which
the product is to be installed.
3.5
Serial number
The serial number is located on a plastic plate at the bottom
of the front casing.
3.6
CE label
The CE label shows that the products comply with the basic
requirements of the applicable directives as stated on the
identification plate.
The declaration of conformity can be viewed at the manufac-
turer's site.
3.7
Benchmark
Vaillant is a licensed member of the Benchmark Scheme
which aims to improve the standards of installation and com-
missioning of domestic heating and hot water systems in the
UK and to encourage regular servicing to optimise safety, ef-
ficiency and performance.
Benchmark is managed and promoted by the Heating
and Hotwater Industry Council. For more information visit
www.benchmark.org.uk.
▶
Please ensure that the installer has fully completed the
Benchmark Checklist on the inside back pages of the
installation instructions supplied with the product and
that you have signed it to say that you have received a
full and clear explanation of its operation. The installer is
legally required to complete a commissioning checklist
as a means of complying with the appropriate Building
Regulations (England and Wales).
All installations must be notified to Local Area Building Con-
trol either directly or through a Competent Persons Scheme.
A Building Regulations Compliance Certificate will then be
issued to the customer who should, on receipt, write the No-
tification Number on the Benchmark Checklist.
This product should be serviced regularly to optimise its
safety, efficiency and performance. The service engineer
should complete the relevant Service Record on the Bench-
mark Checklist after each service.
The Benchmark Checklist will be required in the event of any
warranty.
4
Operation
4.1
Operating concept
Operator
control
element
Function
–
Setting the hot water temperature
–
Cancelling the activation of an operating
mode
–
Cancelling a change to a set value
–
Going one selection level higher
–
Setting the heating flow temperature
–
Reading the system pressure
–
Activating the comfort mode
–
Activating the operating mode
–
Confirm setting
–
Going one selection level lower
+
at
the same
time
–
Calling up the menu
or
–
Reducing or increasing the set value
–
Scrolling through menu entries
The current function of the
and
buttons is shown in
the display.
Adjustable values are always displayed as flashing.
You must always confirm a change to a value. Only then is
the new setting saved. You can press
to cancel a proced-
ure at any time.
4.2
Basic display
50
The basic display shows the current condition of the product.
If you press a selection button, the activated function is dis-
played in the display.
The functions that are available depend on whether a con-
troller is connected to the product.
You can switch back to the basic display by:
–
Pressing
to exit the selection levels
–
Not pressing any button for longer than 15 minutes.
If there is an error message present, the basic displays
switches to the error message.
