Vaillant geoTHERM VWS Series, Installation Instructions Manual

Page: 55 / 92

55
Installation instructions geoTHERM VWS/VWW 0020057444_01
Display shown Description Factory setting
Holiday programming
6
for cpl. System
Periods
1 >06.01.08 08.01.08
2 14.01.08 30.01.08
Room Temp. setpoint 12 °C
>Set starting day
It is possible to program two holiday periods by
specifying the dates for the controller and all
system components connected to it. In addition, you
can set the desired target room temperature for hol-
idays here, i.e.independently of the preset timer pro-
gram. After the holiday time has elapsed, the con-
troller automatically goes back to the previously se-
lected operating mode. The holiday program can be
activated only in auto and eco operating mode.
Connected cylinder charging circuits or circulation
pump circuits are automatically switched to OFF op-
erating mode during the holiday time program.
Period 1:
01.01.2003 –
01.01.2003
Period 2:
01.01.2003 –
01.01.2003
Room Temp. set-
point 15 °C
Basic data
7
Date 21.04.08
Day of
week
Mo
Time 09:35
>Values can be set
In the Basic data menu, you can set the current
date , the day of the week and, if no DCF radio re-
ception is possible, the current time for the control-
ler.
These settings apply to all connected system compo-
nents.
Code layer
8
Code number:
> 0 0 0 0
Standard code:
1 0 0 0
>Adjust numeric character
To access the Code layer (Technician level), enter
the appropriate Code (standard code 1000) and
press the right hand dial .
To view set values without entering the code, you
must press the dial once. You can then view all pa-
rameters of the code level by turning
the dial but not change them.
Security function: Your code entry is reset again
15 minutes after your last change in the Code level
(actuation of one of the dials). To gain entry to the
Code level again after that, you will have to enter
the code once more.
1000
Table 8.3 Parameters that can be set in the Operator level
(cont.)
Controller 8