8
eletronicVED pro series
5 Water heater use
4�4
Special points related to installation
Clean the pipe by water before installation to prevent
residual sediment from clogging the appliance
- Water heater inlet could be either upward or downward.
Water heater will not work normally if the inlet is on the
left or right.
- Filter shall be installed at the inlet. Filter is included in
gasket package. - Fix hanging bracket at the appliance
installation position inside the cabinet. The appliance
should directly hang on the bracket.
- Connect water heater power line and power line on the
wall by wiring board.
- After completing installation, please open the water
firstly without turning on the power.
- Turn on the power when outlet water flows smoothly
without bubbles.
- miniVED plus temperature can be adjusted by using plus
and minus buttons. (normal the temperature setting is
38℃).
- Display temperature will blink if the water temperature
can’t reach the setting temperature then the water flow
needs to be reduced.
- When using miniVED plus, use only hot water and do
not mix hot and cold water.
- 2.5 mm² copper core electric wires are required for
installation. Air-break switch ≥25A.
5
Water heater use
5�1
Usage of water heater
After installation of water heater, please turn on water
mixing tap. Only after confirming that outlet water flows
continuously and there is no water leakage at each joints
can the water heater be turned on.
▶
Starting up
Close the air-break switch (only for the first time use after
installation), adjust the water mixing tap to the appropriate
flow.
- miniVED plus series:
Press the "ON/ OFF" button, the display is bright, and enter
the instant heating mode. The display shows the current
setting temperature.
- miniVED pro series:
Turn on the water tap and start heating.
▶
miniVED plus series (VED E 6/1-P IN)
This appliance is a constant temperature type. The default
setting temperature is 38℃.
▶
miniVED pro series (VED E 6/1-B IN)
This appliance has built-in power constant setting, adjusting
the outlet temperature by adjusting the mixing tap.
▶
Temperature adjustment (miniVED plus)
The water temperature is adjusted by "+" button of
temperature, and 1℃ rise by one press until 48℃ ; the
temperature "-" button is adjusted to reduce the water
temperature, 1 ℃ down by one press. The temperature
adjustment range for users is 30℃-48℃.
▶
Turn off the appliance
After using the appliance, press lightly OFF to turn off the
appliance (miniVED plus).
Turn off the appliance by turning off the water mixing tap
(miniVED pro).
6
Water heater maintenance
The power supply must be disconnected before cleaning
the water heater. Use a damp cloth to dip a small amount of
neutral detergent and gently wipe the water heater, do not
use gasoline or other solutions. Dry the water heater with a
dry cloth and keep the water heater dry.
Caution�
The water heater is heated only when the water
flows and the flow rate is larger than 2L/ Min.
Summary of Contents for EIWH mini VED plus
Page 11: ......
