Vaillant ecoTEC sustain 24, Installation And Maintenance Instructions Manual

Page: 43 / 64

0020253094_05 ecoTEC sustain Installation and maintenance instructions
43
13.7.10 Replacing the power supply cable
Note
The cable must be replaced by the manufacturer,
its customer service or suitably qualified persons
in order to avoid danger.
▶
If the power supply cable is damaged, replace it in ac-
cordance with the recommendations for the power supply
connection. (
→
Page 23)
–
Cross-section of the power supply cable: 3 G
0,75mm
²
13.8 Completing repair work
1. Establish the power supply.
2. Switch the product back on if this has not yet been
done. (
→
Page 29)
3. Install the front casing.
4. Open all service valves and the gas stopcock.
14 Decommissioning
14.1 Permanently decommissioning the product
▶
Press the on/off button.
◁
The display goes out.
▶
Disconnect the product from the power grid.
▶
Close the gas stopcock.
▶
Close the cold-water isolation valve.
▶
Drain the product. (
→
Page 39)
15 Recycling and disposal
Disposing of the packaging
▶
Dispose of the packaging correctly.
▶
Observe all relevant regulations.
▶
For detailed information refer to www.vaillant.co.uk.