1 Safety
6
Installation and maintenance instructions ecoTEC plus 0020134823_07
to corrosion on the product and in the flue
system.
▶
Ensure that the supply of combustion air is
always free of fluorine, chlorine, sulphur,
dust, etc.
▶
Ensure that no chemical substances are
stored at the installation site.
▶
If you are installing the product in
hairdressing salons, painter's or joiner's
workshops, cleaning businesses or similar
locations, choose a separate installation
room in which the room air is technically
free of chemical substances.
1.3.13 Risk of poisoning and burns caused
by escaping hot flue gases
▶
Only operate the product if the air/flue pipe
has been completely installed.
▶
With the exception of short periods for
testing purposes, only operate the product
when the front casing is installed and
closed.
1.3.14 Risk of death from electric shock
There is a risk of death from electric shock if
you touch live components.
Before commencing work on the product:
▶
Disconnect the product from the power
supply by switching off all power supplies
at all poles (electrical partition with a con-
tact gap of at least 3 mm, e.g. fuse or cir-
cuit breaker).
▶
Secure against being switched back on
again.
▶
Check that there is no voltage.
1.3.15 Risk of material damage caused by
frost
▶
Do not install the product in rooms prone
to frost.
1.3.16 Risk of material damage caused by
using an unsuitable tool
▶
Use the correct tool.
1.3.17 Risk of being burned or scalded by
hot components
▶
Only carry out work on these components
once they have cooled down.
1.3.18 Risk of scalding from hot water
There is a risk of scalding at the domestic
hot water draw-off points if the domestic hot
water temperatures are greater than 60 °C.
Young children and elderly persons are par-
ticularly at risk, even at lower temperatures.
▶
Select a moderate set target temperature.
1.4
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, directives, ordinances and laws.
Summary of Contents for ecoTEC plus VU GB 5-5 Series
Page 59: ......
